dpast32 Posted November 1, 2021 Share #1 Posted November 1, 2021 Good Morning Gents, I recently had to order an E.K. II ( Iron Cross ) Replacement Ribbon from Germany to replace the missing one on one of my Medal Groups. ( It's alleged to be from very old stock, but who truly knows ? ) Upon receipt, I thought it appeared somewhat thinner than the usually observed examples, although I could very well be wrong ? It measures exactly 1" / 25 cm in width ? Is this the correct width of the average WW1 Imperial German E.K. II Award Ribbon drape ? Any assistance will be very much appreciated. THANK YOU Best, dpast32 Link to comment Share on other sites More sharing options...
Proud Kraut Posted November 11, 2021 Share #2 Posted November 11, 2021 After doing some research I think the "official" correct width of the medals´ribbon should be 30 mm. I checked an EK II from a friend and it has a 30 mm ribbon as well. Unfortunately I can´t tell you if custom made 25 mm wide ribbons are legit as well but I have noticed that a lot of modern made ribbons are offered everywhere. Link to comment Share on other sites More sharing options...
dpast32 Posted November 11, 2021 Author Share #3 Posted November 11, 2021 Hey, THANK YOU Lars, as always, I truly appreciate your kind replies. I had initially thought that by ordering one from Germany, I would be more likely to receive an original, era production length of ribbon. However, I'm no longer that sure. Thanks again !! Best, Dom P. Link to comment Share on other sites More sharing options...
Kia kaha Posted November 12, 2021 Share #4 Posted November 12, 2021 I can’t give you the measurements at the moment, but ribbon came in different widths for issue, worn on a ribbon bar, worn as a single medal or worn as part of a complete group, or worn on a tunic button hole. Link to comment Share on other sites More sharing options...
Kia kaha Posted November 13, 2021 Share #5 Posted November 13, 2021 The medals I’ve checked are as issued ie un mounted ribbon 30 or 32mm but most medals mounted on a bar the ribbons on these are usually 25mm and 25mm for buttonhole wear here’s a good book on German mounting style s Link to comment Share on other sites More sharing options...
dpast32 Posted November 13, 2021 Author Share #6 Posted November 13, 2021 THANK YOU 'Kia kaha', I deeply appreciate your very kind reply, & efforts to solve the issue as to correct EKII ribbon measurements !! As obtained, the EKII in question was part of an multi piece Group, which IIRC, was discussed here on this Forum not too long ago. As the piece in question was sans ribbon, I thought I should at least obtain an replacement, if only for display purposes. Having ordered it from Germany, & at least 'partially believing' the seller's assurance of it being from 'old stock', I accepted it at face value & purchased it. ( It wasn't very expensive at all. ) So, apparently there are 2 distinct width types of ribbon drape applicable to the EKII Awards, dependent upon the particular mounting style being used. At least for my specific purposes, the 25cm version should suffice just fine, although I do at some point intend to obtain the 30cm version when found. THANKS AGAIN My Friend, I truly appreciate your kind assistance ! Best regards, Dom Pastore Jr. / 'dpast32' Link to comment Share on other sites More sharing options...
Kia kaha Posted November 16, 2021 Share #7 Posted November 16, 2021 On 11/14/2021 at 2:57 AM, dpast32 said: THANK YOU 'Kia kaha', I deeply appreciate your very kind reply, & efforts to solve the issue as to correct EKII ribbon measurements !! As obtained, the EKII in question was part of an multi piece Group, which IIRC, was discussed here on this Forum not too long ago. As the piece in question was sans ribbon, I thought I should at least obtain an replacement, if only for display purposes. Having ordered it from Germany, & at least 'partially believing' the seller's assurance of it being from 'old stock', I accepted it at face value & purchased it. ( It wasn't very expensive at all. ) So, apparently there are 2 distinct width types of ribbon drape applicable to the EKII Awards, dependent upon the particular mounting style being used. At least for my specific purposes, the 25cm version should suffice just fine, although I do at some point intend to obtain the 30cm version when found. THANKS AGAIN My Friend, I truly appreciate your kind assistance ! Best regards, Dom Pastore Jr. / 'dpast32' Here’s a restoration I did, middle medal ribbon is a modern 32mm , the ones either side are the original 25 mm ribbons fitted on the mounting Link to comment Share on other sites More sharing options...
dpast32 Posted November 17, 2021 Author Share #8 Posted November 17, 2021 THANK YOU My Friend, I appreciate your input !! Best, dpast32 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now